|
All products in our LEM collection are finished
without using any water whatsoever
and are produced without
chemicals
so you can be sure nothing goes down your drain.
You can also say goodbye to complaints from your staff and customers about dust and offensive odours. LEM uses light or heat to seal the surface of a foam text plate in just a few seconds so the process is clean and odour free. Much less power is used in the LEM process than any other method currently available. So little, in fact, that a 100 watt globe left on for one hour uses more power than is required to process a batch of LEM stamps! All products in the LEM collection are designed to be re-inked so replacement pads, the waste that they produce and the problems they create in inventory can all be eliminated. In short, the LEM method has the lowest overall environmental impact of any stamp manufacturing method presently available and is the obvious choice for environmentally aware manufacturers and consumers alike.
LEM -
an initiative of Astron
Industries designed to
make it easy for our
customers to
produce rubber stamps
for a greener world.
|
|
LEM - The Collection |
|
|
|
|
LEM - an Overview
|
| << Related Pages >> |
|
|
| << IMPORTANT >> |
|
Multi-Surface Stamps by iStamp June 2010 - Stamps for use on non-porous surfaces are now available in 10 sizes including 2 extra large sizes. Click here to find out more.
iStamp Release June 2010 - A new range of pre-inked stamps is now available. 10 sizes including 2 extra large sizes are now available. Click here to find out more.
Low Emmissions Manufacturing Making rubber stamps can consume enormous amounts of energy while producing large quantities of effluent or waste, not to mention the noxious odours from some methods. Make stamps the clean and efficient way - click here to find out more.
Deskmate 32mm Stamps Coming Soon May 2010 - Deskmate stamps with a 32mm square dieplate are not far away! Off tool samples are currently being tested. we expect stock to be available in the next 2 or 3 months.
More Deskmate models. May 2010 - Deskmate have plans for 4 additional sizes which they hope to introduce over the next 6 months.
|
Blower Motors: To provide optimum airflow over the useful life of the filter material two heavy duty, high static pressure motors are used. These motors are equipped with automatic reset overload protection.
Filtration stages: The vacuum system has 3 main filtration stages. The 1st stage takes out large and medium size particles. The 2nd stage is a HEPA type filter that takes out the smaller particles. The 3rd stage is an activated carbon filter for removal of odor and gases.
Size: 26î(26cm)W x 28î(71cm)D x 62î(158cm)H (with intake hose attached)
Specifications and filter media materials can change without prior notification